Brother QL-500 Instrukcja Użytkownika Pobierz pdf (Strona 54)

STEP4 Maintenance and Troubleshooting

Eventually the cutting blade on the cutter unit will become dull and need to be replaced.

At the appropriate time, purchase a new replacement cutter unit and install it according to

the following procedure. For purchasing a replacement cutter unit, refer to Î"Software

User's Guide (PDF Manual)".

Check that the cutter unit is located to the home position.

Turn OFF the power to this printer and pull out the power cord from

the wall outlet.

Open the DK Roll cover and pull the roll

release lever to the up position. Remove the

DK Roll.

Using a Phillips-head screwdriver, loosen

the screw which holds the cutter blade unit

in-place.

The screw of cutter unit cannot be removed to

prevent the malfunction of the printer.

Hold the knob and carefully remove the

cutter unit.

Take care not to touch the blade of cutter.

Set the new cutter unit at the prescribed position.

Replacing the cutter unit

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 117 118

Brak uwag

Brother QL-500 Instrukcja Użytkownika Strona 54